User Manual

Voice Parameters
40
Control Depth Determines the LFO Wave Depth.
LFO Element Switch Determines whether or not each Element is to be affected by the LFO.
Depth Offset Determines the offset values of the Control Depth parameter for the
respective Elements.
If the resultant Control Depth value is negative, it will be set to 0.
If the resultant Control Depth value is greater than 127, it will be set to 127.
LFO Phase Offset Determines the offset values of the Phase parameter for the respective
Elements.
Figure 50: Phases of a wave
A: Phase
X: Time
Y: Level
Template Selects a pre-programmed setting for creating an original LFO wave.
Slope Determines the slope or ramp characteristics of the LFO wave.
 Off: Creates no slope.
 Up: Creates an upward slope.
 Down: Creates a downward slope.
 Up&Down: Creates an upward then downward slope.
Cycle Determines the amount of steps for creating the LFO Wave.
Step Value Determines the level for each step.
A
X
Y
0
90
120
240
180 270