User Manual

Effects
57
2-3-4 D
Comp Output Level Determines the level of the signal output from the compressor effect.
Control Type This is a parameter of Control Delay.
 Normal: The delay effect is always applied to the sound.
 Scratch: The delay effect is not applied if both the Delay Time and
Delay Time Offset are set to 0.
Damper Control When the half-damper compatible FC3 footswitch is connected to the
SUSTAIN jack, the Damper Control parameter is controlled by the FC3
over a range of 0 - 127, allowing for partial damper effects, such as are
available on an actual grand piano.
Decay Controls how the Reverb sound decays.
Delay Level Determines the level of the delayed sound.
Delay Level C Determines the level of the delayed sound for the center channel.
Delay Mix Determines the level of the delayed mixed sound when multiple effects are
applied.
Delay Offset Determines the offset value of the delay modulation.
Delay Time Determines the delay of the sound in note value or absolute time.
Delay Time C, L, R Determines the delay time for each channel: center, left and right.
Delay Time L>R Determines the amount of time between the moment the sound is input
from the L channel and the moment the sound is output to the R channel.
Delay Time Offset R Determines the delay time for the R channel as offset.
Delay Time R>L Determines the amount of time between the moment the sound is input
from the R channel and the moment the sound is output to the L channel.
Delay Transition
Rate
Determines the speed (rate) at which the delay time is changed from the
current value to the specified new value.
Density Determines the density of the reverberations or reflections.
Depth Determines a specific value, depending on the selected Effect type.
For Space Simulator, this parameter determines the depth of the simulated
room.
For VCM Flanger, this parameter determines the Amplitude of the LFO
wave that controls the cyclic change of the delay modulation.
For Phaser Type, this parameter determines the Amplitude of the LFO
wave that controls the cyclic change of the phase modulation.
Detune Determines the amount by which pitch is detuned.
Device Selects the device for changing how to distort the sound.
Diffusion Determines the spread of the selected effect.
Direction Determines the direction of the modulation controlled by the envelope
follower.
Divide Freq High Determines the high frequency for dividing the entire sound into three
bands.
Divide Freq Low Determines the low frequency for dividing the entire sound into three
bands.
Divide Min Level Determines the minimum level of the portions extracted via the Slice effect.