User Manual

Effects

2-3-15 R

2-3-16 S

Pedal Control When VCM Pedal Wah is selected, this parameter determines the Cutoff

Frequency of the wah filter.

For best results, assign this parameter to the Foot Controller in the

Controller Set display, then use the Foot Controller to control this

parameter.

Pedal Response Determines how the sound responds to changes in the damper control.

Phase Shift Offset Determines the offset value of the phase modulation.

Pitch 1, 2 Determines the pitch in semitones for each of the first series and second

series.

PM Depth Determines the depth of the pitch modulation.

Pre Mod HPF Cutoff

Frequency

Determines the Cutoff Frequency of the High-Pass Filter before the

modulation.

Pre-LPF Cutoff

Frequency

Determines the Cutoff Frequency of the Low-Pass Filter before the

modulation.

Pre-LPF Resonance Determines the Resonance of the Low-Pass Filter for the input sound.

Presence This parameter of the Guitar Amp effect controls high frequencies.

Ratio Determines the ratio of the compressor.

Release Determines the amount of time that elapses between the releasing of a key

and the end of the compressor effect.

Release Curve Determines the release curve of the envelope follower.

Release Time Determines the release time of the envelope follower.

Resonance Determines the Resonance of the filter.

Resonance Offset Determines the Resonance as offset.

Reverb Delay Determines the delay time from the early reflections until the

reverberations.

Reverb Time Determines the Reverb time.

Room Size Determines the size of the room in which the instrument sounds.

Rotor Speed Fast Determines the speed of the rotor when the slow/fast switch is set to Fast.

Rotor Speed Slow Determines the speed of the rotor when the slow/fast switch is set to Slow.

Rotor/Horn Balance Determines the volume balance of the horn and rotor.

Sampling Freq.

Control

Controls the sampling frequency.

Sensitivity Determines a specific value, depending on the selected Effect type.

For Dynamic Flanger, Dynamic Phaser, and the Tech effects, this

parameter determines the sensitivity of the modulation applied to the input

change.

For VCM Touch Wah effects, this parameter determines the sensitivity of

the wah filter's change applied to the input change.