User Manual
Table Of Contents
- System Requirements
- Installation
- Installing Speaker Data
- Uninstalling
- Table of Contents
- 1. Y-S3 General Operation
- 2. Constructing the Room Shape & Audience Area
- 3. Editing Project Properties
- 4. Placing Speakers
- 5. Adjusting Speaker Parameters
- 5-1. Speaker Arrays
- 5-2. Distributed Speakers
- 6. Displaying Calculation Results
- 7. Simulation Results Report
- 8. Exporting Configurations in DME Designer Format
- 9. Other Functions
- 10. General Theory
Yamaha Sound System Simulator Y-S
3
Owner’s Manual V3.1
16
Select Venue Geometry(Step2/2):
Edit the selected shape with the Top View and Right-Side View. Use your mouse to select an orange point on a view
(selected point turns black), then drag the point to the desired position. You may also select a point, and enter the
desired three-dimensional coordinates. The range of each dimension is shown below. Note that for the 2nd to the
4th floors, y is the distance from the reference point. The reference points of the 2nd to the 4th floors can be varied
between of -100.00 m to 100.00 m (-328.08 ft to 328.08 ft)..
x : width y : depth z : height
Stage -45.00m~-0.01m
(-147.64~-0.03ft)
-90.00m~90.00m
(-295.28ft~295.28ft)
0.00m~2.00m
(0.00ft~6.56ft)
1st Floor -45.00m~-0.01m
(-147.64ft~-0.03ft)
-90.00m~90.00m
(-295.28ft~295.28ft)
0.00m~45.0m
(0.00ft~147.64ft)
2nd ~4th Floor
-60.00m~-0.01m
(-196.85ft~-0.03ft)
-90.00~90.00m
(-295.28ft~295.28ft)
0.00m~50.0m
(0.00ft~164.04ft)
You can change the zoom for Top View and Right-Side View by clicking
If there are multiple floors, edit the shape for each floor. Select a template from the left side, and edit the shape. If
you change the template after setting the coordinates of each point, the coordinates will be reset.