Operation Manual

On-screen Messages
58 CP5/CP50 Owner’s Manual
Appendix
Please select a left or right part.
This message is displayed if the [VOICE], [PRE-AMP], [MOD-FX], or [PWR-AMP]
button is pressed even though the currently selected part is not a left or right part.
The blocks corresponding to these buttons can only process sound from the left
and right parts.
Please select a piano voice.
This message is displayed if the [PRE-AMP] button is pressed even though the
currently selected part has been assigned a non-piano voice. The Pre-Amplifier
block can only process sound from parts with a PIANO or E.PIANO voice.
Please stop sequencer.
This message is displayed to remind you to stop backing-track playback.
Read only file.
This message is displayed if you attempt to delete, rename, or overwrite a read-
only file.
Receiving MIDI bulk...
This message is displayed while your CP5 or CP50 is busy receiving data created
using the Bulk Dump function.
Recording...
This message is displayed while your CP5 or CP50 is busy recording a User Song
or Wave file.
Recording stopped.
This message is displayed if recording was stopped as a result of insufficient
sequencer memory.
Saving... [EXIT] to cancel.
This message is displayed while your CP5 or CP50 is busy saving a file.
Scanning autoloaded files.
This message is displayed while your CP5 or CP50 is busy scanning for a file to
be loaded automatically.
Seq data is empty.
This message is displayed if you attempt to save a User Song that does not
contain any data.
Seq data is not empty.
This message is displayed if you attempt to record a User Song even though all
User Songs already contain data.
Seq memory full.
This message is displayed if recording, reception of MIDI data, or the loading of
data from a USB flash-memory device cannot be carried out as a result of the
stage piano’s internal sequencer memory already being full. In order to remedy
this situation, unneeded User Songs should be deleted.
Transmitting MIDI bulk...
This message is displayed while your CP5 or CP50 is busy transmitting MIDI bulk
data.
USB communication failed.
This message is displayed if an error occurs while communicating with a USB
flash-memory device.
USB connection terminated.
This message is displayed if connection with a USB flash-memory device was
lost due to abnormal electric current.
USB device full.
This message is displayed if a USB flash-memory device is full and no more files
can be saved on it. In such a case, use a new USB flash-memory device or make
space by erasing unwanted data from the current device.
USB device is not responding.
This message is displayed if the USB flash-memory device plugged into the USB
TO DEVICE port fails to respond.
USB device not ready.
This message is displayed if a USB flash-memory device has not been correctly
plugged into your CP5 or CP50.
USB device read/write error.
This message is displayed if an error occurs while reading data from, or writing
data to, a USB flash-memory device.
USB device unformatted.
This message is displayed if the plugged-in USB flash-memory device is either
unformatted or formatted in a way that your CP5 or CP50 does not support. In
such a case, check the content of the USB flash-memory device.
USB device write protected.
This message is displayed if the USB flash-memory device has been write
protected.
USB power consumption exceeded.
This message is displayed if the current being drawn by the USB flash-memory
device exceeds the level supported by your CP5 or CP50.
Utility & MComp stored.
This message is displayed when Utility settings, Master Compressor settings, and
other system settings have been successfully stored.
Working...
This message is displayed while your CP5 or CP50 is saving or loading data or
when the [EXIT] button has been pressed to cancel an operation. It will disappear
when the processing required for cancellation has been completed.
Message Description