Operation Manual

9
Setup Procedures
Serial Number
Once you have taken the CRW2100S drive out of its packaging, you should
immediately note down the serial number found at the top of the drive with the
bar code. You may need to refer to this number when requesting Customer
Support services. In the box below the following diagram, write down the 10-
character serial number (consisting of 3 letters followed by 7 digits).
Serial number
(3 letters and 7 digits)
Serial No.
SCSI Settings
Before fitting the CRW2100S drive into the computer, you need to set up the
drive using the jumper switches located at the rear of the unit. You’ll need to set
the following:
● SCSI ID number
● Parity check
● Termination
● Block size