Operation Manual

Setup Procedures
18
6 Connect one end of the 50-pin SCSI flat cable to the computer’s
SCSI card. Align the red line of the cable with Pin 1 of the card’s
SCSI connector. Next, connect a free 50-pin connector on the SCSI
flat cable to the back of the CRW2100S drive such that the red line
on the cable is aligned with pin 1, marked “SCSI INTERFACE
CONNECTOR 1.”
AUDIO OUT
ID SELECT
PARITY
TERMIN ATOR
BLOCK SIZE
DC INPUT
1
+
5V G
+
12
V
RL124G
SCSI
INTERFACE
CONNECTOR
SCSI
INTERFACE
CONNECTOR
1
SCSI card
50-pin SCSI flat cable
Align red line
with Pin 1 of
SCSI INTERFACE
CONNECTOR 1
To Pin 1
Pin 1
Pin 1
Mark
Align red line with
Pin 1 of SCSI INTERFACE
CONNECTOR 1
About SCSI card termination
To connect internally-mounted SCSI devices, the SCSI card’s on-board
internal SCSI termination must be switched ON. With most cards, this is
done automatically. If your SCSI card requires that you manually disable
internal termination, refer to the documentation that came with it.