User Manual

Setup Procedures
Additional DriveReplacing Drive
14
7 Remove the four screws holding the CD-ROM drive in place, then
slide the drive forward and out of the drive bay.
Before removing the CD-ROM drive from the computer, make
sure that all the cables have been removed from the CD-ROM
drive’s rear panel.
n Do not force pulling or apply excessive force to the CD-ROM drive.
About IDE 2
Yamaha recommends one of the following connections.
Example-2: As secondary master
If you disconnect the IDE
device and re-connect it to
another location, other
devices connected to the
IDE cable may become slow
in processing, unstable, or
inoperative.
If the 40-pin IDE cable has
only one connector available
but you wish to re-connect
the IDE device (that you just
disconnected) to another
location, use a 40-pin IDE
cable that has two
connectors.
If you connect only one IDE
device to an IDE cable,
assign the device as a
master and connect it to the
end of the cable.
Example-1: As secondary slave
IDE cable (Secondary)
No Device
(slave)
Connect
CRW2100E
IDE cable (primary)
CD-ROM Drive etc.
(slave)
Hard Disk
(master)
(master)
IDE cable (primary)
IDE cable (Secondary)
Connect
CRW2100E
(slave)
Hard Disk
(master)
Hard Disk
(slave)
CD-ROM Drive etc.
(master)
n The CRW2100E drive is shipped with the SLAVE setting. Reset to MASTER if
you connect the drive solely to the secondary IDE cable.