User manual

Setup Procedures

Connections

Before connecting the CRW2100IX drive and the computer as described

below, make sure that you have installed appropriate CD writing software

(P. 3, 4). If you use Windows and in case newly install the CD writing

software, first disconnect all IEEE1394 devices from your computer. After

properly installing the software, you are ready to connect the devices. For

information about how to install the software, refer to the documentation

that came with it.

If your computer has no built-in IEEE1394 port, you will first need to install an

IEEE1394 interface card (purchased separately). For information about how to

install the card, refer to the documentation that came with it.

1 Make sure that the computer is turned on.

2 Make sure that the drive is turned OFF (the POWER switch is not

depressed).

Power ON Power OFF

3 Connect the supplied power cable to the AC IN socket on the drive’s rear panel.