User manual

Setup Procedures
Verifying the Hardware Installation
After connecting the CRW2100IX drive to the computer (or an IEEE daisy-chain
or tree), you can verify that the drive is correctly recognized from your computer.
Windows Users
Make sure that the CRW2100IX is recognized by the operating system.
From the Windows 98 Second Edition’s [Start] menu, select [Settings]-[Control
Panels] and open the [System] control panel. In the [System Properties] window,
select the [Device Manager] tab. If you can find a new CD drive icon (YAMAHA
CRW2100E), an IEEE1394 bus controller icon, and an SBP2 icon as shown below,
you have successfully installed both the drive and the IEEE1394 interface card as
Windows OS recognizes both devices.
If the devices are not recognized, read the instructions on p. 10 - p. 12 carefully
and redo the setup procedures.
This screen shot is from Windows 98 Second Edition.
n With Windows Me, you can make sure that the CRW2100IX is recognized with the same
method as Windows 98 Second Edition.
n For details about how to use the operating system, refer to the documentation that came
with it.
n If there is a mark next to the icon for the CRW2100IX drive or the IEEE1394 bus
controller, this means that it has not been installed correctly. In either case, the
CRW2100IX drive may not work properly.
n For Windows 2000 Professional, double-click [System] in the [Control Panels], select
the [Hardware] tab, and click the [Device Manager] button in [System Properties].
16