Owner`s manual

To set each jumper switch, you have to bridge the two pins in the respective
column of the grid with a plastic shunt. Shunts are already attached to the
jumper switches in their default configurations.
n The plastic shunts actually contain metal for bridging the two pins of a jumper switch, creating
an electrical connection between them when attached. When removed, the jumper switch is
set to “off.” Store unused shunts in a safe place where they will not be lost.
Use a pair of long-nosed pliers to attach or detach the shunts accordingly.
However, make sure that the computer is switched off when doing so.
AUDIO OUT
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
SCSI
INTERFACE
CONNECTOR
DC INPUT
1
+
5V G
+
12
V
R L 1 2 4G
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
1 2 4
Rear Panel
Jumper switches
Shunt
9
Installation
6416S_e15.qx 6/29/99 6:00 PM Page 16