Owner`s manual

27
Installation
9 Connect the audio cable between the CRW6416S drive and the computer’s
sound card, or the motherboard’s audio connector if it has built-in audio.
One end of the audio cable has two connectors: a smaller type and a larger
type. Choose one that matches your sound card’s connector. The connector
at other end of the cable is connected to “AUDIO OUT” of the CRW6416S
drive. Make sure connector’s lug is at the top.
n You do not need to connect the audio cable to write audio CDs since the audio is passed over
the SCSI bus. It is required for playing back audio CDs on the CRW6416S drive via the
computer’s sound card. However, if a CD-ROM drive is already connected to the sound card,
you should use this drive to play back your audio CDs. To listen to audio CDs without a
computer sound card, connect headphones or speakers to the headphone jack on the
CRW6416S drive’s front panel.
Sound card
AUDIO OUT
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
SCSI
INTERFACE
CONNECTOR
DC INPUT
1
+
5V G
+
12
V
R L 1 2 4G
6416S_e15.qx 6/29/99 6:00 PM Page 34