Owner`s manual

35
The drive ejects or fails to read the disc, or the ON/DISC LED
continues to blink in orange after the disc has been loaded
(meaning that the disc has not been recognized).
● Disconnect the SCSI cable from the drive but leave the power cable connected,
then load a disc.
● You may be trying to write to an unusable disc. If the drive fails to write to a
variety of different discs, it may be faulty and you should contact your nearest
Yamaha dealer.
The “Buffer Underrun” error message is displayed.
● Try the following:
• Lower the writing speed setting (e.g., from 4x speed to 2x speed).
• Create an image file of the CD on the computer’s hard disk.
• Defragment the hard disk.
• Turn hard disk power management off.
• Deactivate the Active Desktop (if you are using Internet Explorer 4).
• Disable network access.
• Close other applications (including screen savers, task schedulers, etc.).
n Errors can occur if you knock the CRW6416S drive while it is writing to disc.
n When using packet writing on a CD-RW disc, the actual data capacity is 100MB less than that
stated on the cover of the disc. The difference in capacity is dependent on the writing mode.
Troubleshooting
6416S_e15.qx 6/29/99 6:00 PM Page 42