Technical information

Chapter 2 43
Setting a Password
Follow these steps:
1.
Use the cursor w/y keys to highlight a Password parameter (Supervisor Password, User Password, or
Primary Hard Disk Password) and press thee key. The password box appears as below if choosing
Set Supervisor Password:
2.
Type a password. The password may consist of up to eight characters (A-Z, a-z, 0-9) and then press
e.
IMPORTANT:
Be very careful when typing your password because the characters do not appear on the
screen.
3.
Retype password to verify your first entry and then press
e. The following screen appears:
4.
After setting the password, the computer automatically sets the chosen password parameter to Present.
5.
Press
^ to return to the main menu.
6.
Press
u. The following dialogue box appears.
7.
Select
Yes
and press
e to save the password and exit the BIOS utility.
Set Supervisor Password
Enter New Password [ ]
Confirm New Password [ ]
Set Supervisor Password
Enter New Password [ ]
Confirm New Password [ ]
Setup Notice
Changes have been saved.
[Continue]
Setup Notice
Changes have been saved.
[Continue]
Setup Confirmation
Save Configuration changes and exit now?
[Yes] [No]
Setup Confirmation
Save Configuration changes and exit now?
[Yes] [No]