Technical information

70 OpenBook 1556
8.
Disconnect the touch pad cable from the touch pad board.
9.
Release the touch pad cable from the upper case, remove the two screws, slide the touch pad holder
module as shown and then detach the touch pad holder module from the upper case.
NOTE:
When attaching the touch pad holder module back to the upper case, make sure the latches are
installed well when you slide it to install.
Removing the Touch Pad FPC
1.
See “Removing the Battery” on page 55
2.
See “Removing the Middle Cover” on page 59
3.
See “Removing the Keyboard” on page 60
4.
See “Removing the Antennas” on page 61
5.
See “Removing the LCD Module” on page 64
6.
See “Separating the Upper Case from the Lower Case” on page 68
7.
See “Removing the Touch Pad Holder Module” on page 69
8.
Detach the touch pad FPC in the way as shown.