User Manual
131
SNMP Support Details
The CS-700 includes an SNMP agent that can be configured to provide SNMP
support.
The table below describes the SNMP configuration settings that the CS-700
administrator must configure to enable SNMP.
snmp-enable
Enable or disable SNMP support. Disabled (0) means that SNMP is not
supported. Enabled (1) means that SNMP is available. Default is 0.
snmp-address
Specifies SNMP server address to which traps will be sent. Leave blank to
disable traps.
snmp-community
Specifies the SNMP read-only community string used for queries from the
server and transmitted traps. Read-only indicates the authorization level.
The device does not support write operations initiated through SNMP.
Default value is 'public'.
snmp-contact-name
Specifies the contact name, typically the system administrator. This string
is informational and can include an email address. It is not associated with
traps.
snmp-device-location
Specifies the location of the device for informational purposes.
The following read-only properties and traps are supported.
Read-only Properties
• Serial number
• Base FW version
• USB connection active (0,1)
• USB microphone audio stream active (0,1)
• USB speaker audio stream active (0,1)
• USB video stream active (0,1)
• Bluetooth connection active (0,1)
• VoIP call active (0,1)
Traps
• USB connection state changes