User Manual

19
assembly up or down to the desired angle. As the camera rotates, mechanical
detents within the camera mechanism will lock the camera into position. You
will hear clicking sounds as the detents engage.
Important Note - When adjusting the manual vertical camera angle do not force or
over stress the mechanism as this could damage the camera mechanism. The
mechanism will stop when it reaches the maximum adjustment, do not apply force
beyond the maximum adjustment. Damage to the camera mechanism caused by
excessive manual force will void warranty.
Procedure for camera angle adjustment
1. Connect a PC through the CS-700 USB cable, and enable UC software, a
local PC camera application, or the Service Application.
2. Engage the UC Software / PC application / Service Application to display
the CS-700 camera onto the local PC screen. This provides immediate
feedback as to how the room appears on the far-side of a video
conference.
3. Engage the Camera Vertical Angle Adjustment as described above to
achieve a well-aligned capture of meeting room participants around the
table. Alignment should balance participants in the middle of the video
shot.
Note: The camera angle is adjusted simply by rotating the camera assembly up
or down using the screwdriver shaft as a lever – there is no actual screw
to adjust.
Camera Angle Adjustment