User Manual

26
Power Saving Settings
The CS-700 unit will automatically enter into Power Saving Mode whenever idle
state is detected, and re-energize when activity is detected. This feature is
controlled through the Enable Power Saving Mode checkbox. When the power
savings setting is enabled, the user can select the time (in minutes) after which
the system will go into power savings mode. This feature is set by factory
default with a 20 minute power savings time.
The CS-700 will wake up when activity is detected, either on the Aux in, the
USB connection, or a button is pressed. Please allow about 10 seconds for the
system to wake up.
When the SIP interface is configured on the CS-700SP due to the requirements
of the network and SIP interface, the unit will not go into sleep mode.