User's Manual
Table Of Contents
- Online Resources
- Contents
- Introduction
- About this Manual
- Getting Started
- User Interface
- Dialer Application
- Basic Operations
- Configuring the CS-700
- Configuring using the Web User Interface
- Configuring using the Service Application
- Configuring using a Provisioning Server, Option 66
- Configuring using a Provisioning Server, Option 150
- Provisioning file
- Provisioning file parameters (All Models)
- Using the Application Programming Interface (API)
- USB API functions
- Telnet / SSH interface
- USB/Telnet/SSH CLI Commands
- usb-conn-status
- speaker-volume
- ringer-volume
- speaker-mute
- mute
- camera-ptz-home
- camera-image-defaults
- camera-backlight
- camera-mute
- camera-pan
- cam-pan-left
- cam-pan-right
- camera-tilt
- cam-tilt-up
- cam-tilt-down
- camera-zoom
- cam-zoom-in
- cam-zoom-out
- cam-apply-defaults
- cam-image-apply-defaults
- status
- status-all
- call-info
- start-time
- dial
- answer
- hangup
- hold
- resume
- swap
- join
- transfer
- vm-count
- do-not-disturb
- dtmf
- registration
- Upgrading the Device Firmware
- Appendix
- Limited Warranty and Limitation of Liability
131
SNMP Support Details
The CS-700 includes an SNMP agent that can be configured to provide SNMP
support.
The table below describes the SNMP configuration settings that the CS-700
administrator must configure to enable SNMP.
snmp-enable
Enable or disable SNMP support. Disabled (0) means that SNMP is not
supported. Enabled (1) means that SNMP is available. Default is 0.
snmp-address
Specifies SNMP server address to which traps will be sent. Leave blank to
disable traps.
snmp-community
Specifies the SNMP read-only community string used for queries from the
server and transmitted traps. Read-only indicates the authorization level.
The device does not support write operations initiated through SNMP.
Default value is 'public'.
snmp-contact-name
Specifies the contact name, typically the system administrator. This string
is informational and can include an email address. It is not associated with
traps.
snmp-device-location
Specifies the location of the device for informational purposes.
The following read-only properties and traps are supported.
Read-only Properties
• Serial number
• Base FW version
• USB connection active (0,1)
• USB microphone audio stream active (0,1)
• USB speaker audio stream active (0,1)
• USB video stream active (0,1)
• Bluetooth connection active (0,1)
• VoIP call active (0,1)
Traps
• USB connection state changes