User's Manual
Table Of Contents
- Online Resources
- Contents
- Introduction
- About this Manual
- Getting Started
- User Interface
- Dialer Application
- Basic Operations
- Configuring the CS-700
- Configuring using the Web User Interface
- Configuring using the Service Application
- Configuring using a Provisioning Server, Option 66
- Configuring using a Provisioning Server, Option 150
- Provisioning file
- Provisioning file parameters (All Models)
- Using the Application Programming Interface (API)
- USB API functions
- Telnet / SSH interface
- USB/Telnet/SSH CLI Commands
- usb-conn-status
- speaker-volume
- ringer-volume
- speaker-mute
- mute
- camera-ptz-home
- camera-image-defaults
- camera-backlight
- camera-mute
- camera-pan
- cam-pan-left
- cam-pan-right
- camera-tilt
- cam-tilt-up
- cam-tilt-down
- camera-zoom
- cam-zoom-in
- cam-zoom-out
- cam-apply-defaults
- cam-image-apply-defaults
- status
- status-all
- call-info
- start-time
- dial
- answer
- hangup
- hold
- resume
- swap
- join
- transfer
- vm-count
- do-not-disturb
- dtmf
- registration
- Upgrading the Device Firmware
- Appendix
- Limited Warranty and Limitation of Liability
33
The Pairing and Connection Timeout setting allows control over the Bluetooth
Basic Rate pairing mode and connection mode timeout in seconds. After this
time, pairing mode or the connecting mode will terminate. A value of 0
indicates no timeout. The default value is 60 sec.
The “Bluetooth call auto-join” allows a Bluetooth call on the paired and linked
Bluetooth device to automatically join a conference if there is no dialer control
app. System defaults to Bluetooth call auto-join – disabled.
The “Bluetooth device auto-unpair” allows CS-700 to automatically unpair a
linked Bluetooth device when that device disconnects. This option will prevent
Bluetooth auto-connection. When this option is enabled, a pairing operation is
required for each Bluetooth connection. System defaults to Bluetooth device
auto-unpair - disabled.
Calls