User Manual

CS-800 User Guide
19
Setup and connections
Installing the terminal cover
After connecting the cables to the rear panel of the device, install the terminal cover. This prevents the cables from
becoming disconnected and protects the ports/jack from dust.
Attach the terminal cover to the device by using the two included terminal cover screws (2.5 mm × 8 mm).
Installing the table stand
Attaching the included table stand allows you to use the device placed on a surface such as a table.
With the hexagonal wrench, use the included hexagonal screws (M3 × 8 mm) to attach the table stand to the device.
Terminal cover
Terminal cover screw
(2.5 mm × 8 mm)
* For illustrative purposes, the cable is not shown.
Table stand
Device (rear panel)
* For illustrative purposes, the cable is not shown.
Hexagonal screw (M3 × 8 mm)
for table stand