Operation Manual

ManualsBrandsYamaha ManualsAudioCS6R

Voice Mode

Menu Display

You will see the following if you use the [PAGE]

knob while holding down the [SHIFT] key. Use the

[PAGE] knob to move the cursor to the parameter

you wish to edit, then release the [SHIFT] key to

jump to the screen you were previously at.

Selecting a Menu

On the CS6x in Voice Edit Mode, you can directly

select a Menu using the PROGRAM/PART keys, [1]

to [6] and [9] to [15]. Each key has an associated

Menu name shown below it.

Common General

You can set the Voice Name, Voice output settings and other

general parameters in the Common Edit screens. The

following two screens are available for general settings.

GEN Name (General Name)

GEN Other (General Other)

PROGRAM

PART

1 2 3 4 5 6 7 8

9 10 11 12 13 14 15 16

GENERAL QED ARPEGGIO CONTROL COM LFO EFFECT

OSC PITCH FILTER AMPLITUDE LFO EQ PLG

SHIFT PAGE

PART

ELEMENT

DATAA B C 1 2

GENíOther) Com:>GEN≥QED>ARP>CTL>LFO>EFF

C 1234 Elem:>OSC>PCH>FLT>AMP>LFO>EQ

Cursor

FLT Sens (Filter Sensitivity) 95

FEG VelSens (FEG Velocity Sensitivity) 95

FEG Time 96

FEG Level 96

FEG Release 96

FLT KeyFlw (Filter Key Follow) 96

FLT Scale (Filter Scale Break Point) 97

FLT Scale (Filter Scale Offset) 97

Element Amplitude 98

AEG VelSens (AEG Velocity Sensitivity) 98

AEG Time 98

AEG Level 98

AEG Release 98

AEG KeyFlw (AEG Key Follow) 99

AEG Scale (AEG Scale Break Point) 100

AEG Scale (AEG Scale Offset) 100

Element LFO (Low Frequency Oscillator) 100

LFO Wave 100

LFO Depth 101

Element EQ (Equalizer) 101

EQ Type 101

EQ Param (EQ Parameter) 101

GEN Name (General Name)

You can set a Voice Name consisting of up to 10

characters. You can also select the Category Name to

the left of the Voice Name.

Setting the Voice Name

1 Use Knob [2] to move the cursor to the position of

the first character. The selected character will blink.

2 Use Knob [C] to enter an alphabetic character or

Knob [1] to enter a numeric character/symbol.

3 Use Knob [2] to move the cursor to the position of

the next character.

4 Repeat Steps 2 and 3 until all the characters have

been set for your Voice Name.

You can also use the [INC/YES] and [DEC/NO]

keys or the [DATA] knob to enter alphabetic and

numeric characters as well as symbols.

5 Use Knob [B] to set the Category Name if

necessary.

By setting the Category Name, it will be easier to

identify the Voice later. The Category Search

function (Page 77) can also be used to search for

it. If you do not wish to set a Category Name, the

Category will be shown as two hyphens.

Settings for alphabetic and numeric

characters and Category Names :

LCD