User Manual

Configuration screens
Reference Manual
TF Series
- 39 -
Configuration screens
INPUT screen
Allows you to change the stereo link setting, select an input source, turn phantom power on
and off, turn phasing on and off, and adjust input gain.
1 Stereo link selection button
Allows you to select whether two adjacent mono input channels are linked as a stereo
pair, or behave as two separate mono channels. Touch to display the popup menu.
OFF: Stereo link is disabled.
CH1 & 2: Stereo link is enabled. When stereo link is enabled, the odd numbered channel
is the left side of the stereo pair, and the even numbered one is the right. The
channel numbers displayed in the popup menu depend on the channel
whose settings you are editing.
CH2 & 3: Stereo link is enabled. When stereo link is enabled, the even numbered
channel is the left side of the stereo pair, and the odd numbered one is the
right. The channel numbers displayed in the popup menu depend on the
channel whose settings you are editing.
2 Input selection buttons
Allows you to select the channel's input source. The available sources depend on the
channel whose settings you are editing.
INPUT:The device connected to the INPUT jack will be used as the input source.
USB: The computer connected to the USB TO HOST connector will be used as the
input source.
3 GainFinder
Displays the input's gain adjusted level. When adjusting the input gain, adjust it so that
the center of the GainFinder lights up. When the input source is set to INPUT, the
GainFinder displays the digital input's gain.
4 Level meter
Displays the gain adjusted level.
5 Digital gain text box
Allows you to adjust digital gain the default setting is 0 dB. You can touch the text box
to highlight it, then use the [TOUCH AND TURN] knob to adjust the setting. You can
also touch the text box again to adjust the setting using the keyboard screen.
6 Φ (phase) button
Allows you to reverse the phase.
When turned on, the input signal's phase is reversed.
7 Gain slider
When the INPUT button is selected, the slider adjusts the analog gain of the head amp.
The PAD (-24 dB) will be switched on or off when the analog gain is adjusted between
+17 dB and +18 dB.
When the USB button is selected, the slider adjusts digital gain.
8 +48V button
Turns phantom power (+48 V) to the head amp on and off.
On: Phantom power is turned on.
Off: Phantom power is turned off.
When the USB button is selected, the +48V button is not displayed.
NOTE
When USB is selected, the gain slider (7) adjusts digital gain, and the +48V button (8) is not
displayed.
ձղ ճմ
յնշո
չ
NOTICE
Information about phantom power
When phantom power is not needed, set the +48V button to the off position.
Observe the following when using phantom power to prevent damage to the console or connected
devices, and signal noise.
• Do not set the +48V button to the on position when the device connected to the input jack does
not require phantom power.
• Do not connect or disconnect cables when the +48V button is set to the on position.
• Before turning phantom power on or off for a channel, first set the channel's volume to the
minimum level.
NOTE
When using phantom power, noise may be generated if there is a difference in the impedance between
the hot and cold of the device connected to an input jack.