User Manual

Configuration screens

Reference Manual

TF Series

SEND TO AUX screen

Allows you to configure the amount of signal that is sent from each channel to the AUX buses.

You can swipe left and right to view other buses.

1 Send button

Determines whether a signal is sent (on) or not sent (off) to the corresponding AUX bus.

2 Send level slider

Determines the amount of signal sent to the corresponding AUX bus.

3 Pre button

Allows you to select whether the pre-fader or post-fader signal is sent to the

corresponding AUX bus.

On: Before the fader

Off: After the fader

4 Send pan slider

Displayed for stereo AUX buses. Allows you to adjust the pan of the signal sent to the

corresponding AUX bus.

Adjusting the SEND TO AUX level

1. Adjust the level sliders as desired.

Each level slider determines the amount of signal sent from

the selected channel to the corresponding AUX bus.

2. Turn the Pre button on or off depending on your

needs.

Send the pre-fader signal when using the AUX bus for on-stage floor monitors—this allows you to

create a mix that is separate from the main mix.

Send the post-fader signal when using external effects processors or when you want to maintain the

same mix balance as the main mix.

3. Turn the send button on or off.

When turned on, the signal is sent to the corresponding AUX

bus.

4. Touch the send pan slider and then adjust it using the [TOUCH AND TURN] knob.

When sending the signal to a stereo AUX bus, you can adjust the pan of the signal that is sent.