Operation Manual

iPhone/iPad Connection Manual
8
 Connecting with a USB Wireless LAN Adaptor
1
Turn off the power to the instrument.
Quit any open application software on your iPhone/iPad.
2 Connect the USB Wireless LAN Adaptor to the [USB TO DEVICE] terminal of the instrument.
3 Turn on the power to the instrument.
4 Display the Networks in the wireless LAN display of the instrument.
NOTE For more information on displaying networks in the wireless LAN display of the instrument, refer to the Owner’s
Manual or the Reference Manual of your instrument.
For example, on the CVP-609/605: Menu  [Wireless LAN]
NOTE If no signal from the access point is received, the access point cannot be listed. Also, closed access points cannot
be listed.
5 Connect the instrument to the access point.
From the Networks listed on the display, select the desired one. For a network with a lock icon ( ), you need to
enter the password, and for the network without the lock icon, you can connect the network only by selecting it.
When connection is done successfully, “Connected” is shown at the top of the display, and the icon shown
below appears according to the signal strength.
Required devices
•USB Wireless LAN Adaptor specified for your instrument
•Access point with router (This is unnecessary if your modem has router capability. Moreover, no Access Point is required if
the instrument has the Access Point mode function; see page 12.)
iPad
iPhone
Access point
Wireless
LAN
Wireless
LAN
USB Wireless
LAN Adaptor
Strong Weak