User Manual

CVP-909/CVP-905 Owner’s Manual
118
5 Install the pedal box.
1 Remove the twist tie and tape that affix the pedal cord
to the upper portion of the pedal box.
.
2 Attach the front side of the pedal box to the bottom of
the unit by finger-tightening the two fixing screws (6 ×
20 mm).
3 Insert the lyre braces into the pedal box recesses and
make sure they fit securely.
4 Align the cord with the groove on the unit and attach
the backside of the pedal box using the two fixing
screws (6 × 20 mm), and then securely tighten the
two screws of the front side of the pedal box that were
attached in step 5-2.
5 Loosen the four screws that were attached in step 3,
and then securely tighten the four screws again while
pushing the lyre braces in the direction of arrows as
illustrated.
6 Insert the pedal cord plug into the pedal connector.
Insert the plug so the arrow side faces front (toward
the keyboard).
If the plug will not go in easily, do not force it. Double-
check the orientation of the plug, then try again.
7 Attach the cord holder to the bottom of the main unit
as shown, then clip the holder around the cord.
Twist tie
Tape
6 × 20 mm
fixing screws
6 × 20 mm fixing screws
6
7
Insert the pedal
cord securely
until the metal
part of the cord
plug disappears
from view.
Otherwise, the
pedal may not
function properly.