User Manual

CVP-909/CVP-905 Data List
Effect Parameter List / Liste der Effektparameter / Liste des paramètres d’effets / Lista de parámetros de efectos
84
VIBE VIBRATE
Block: Chorus, Variation, Insertion1 – 28
UNI COMP
Block: Variation, Insertion1 – 28
(*) When UNI COMP is used with System connection in a Variation Block, the “Clipper Source”
parameter will always refer to the “Wet” signal, even if “Dry+Wet” is selected.
VINTAGE COMPRESSOR
Block: Variation, Insertion1 – 28
COMPRESSOR
Block: Variation, Insertion1 – 28
MULTI BAND COMP
Block: Variation, Insertion1 – 28
NOISE GATE
Block: Variation, Insertion1 – 28
3BAND EQ
Block: Variation, Insertion1 – 28
2BAND EQ
Block: Variation, Insertion1 – 28
No. Parameter Display Min Max Table Control
1 Rotor Speed 0.00Hz – 39.7Hz 0 127 Table #8
2 AM Depth 0 – 127 0 127
3 PM Depth 0 – 127 0 127
4
5
6 EQ Low Frequency 32Hz – 2.0kHz 4 40 Table #3
7 EQ Low Gain -12dB – 0dB – +12dB 52 76
8 EQ High Frequency 500Hz – 16kHz 28 58 Table #3
9 EQ High Gain -12dB – 0dB – +12dB 52 76
10 Dry/Wet D63>W – D=W – D<W63 1 127
11 EQ Mid Frequency 100Hz – 10kHz 14 54 Table #3
12 EQ Mid Gain -12dB – 0dB – +12dB 52 76
13 EQ Mid Width 0.1 – 12.0 1 120
14 LFO Phase Difference -180deg – 0deg – +180deg
(resolution=3deg.)
4 124
15 Input Mode Mono, Stereo 0 1
16 Rotor SW Off, On 0 1 
COMPRESSOR/NOISE GATE
No. Parameter Display Min Max Table Control
1 Threshold -60.0dB – 0.0dB 0 120
2 Knee 0 – 8 0 8
3 Attack 0.010ms – 80.00ms 0 127 Table #30
4 Release 6.250ms – 999.0ms 0 127 Table #31
5 Ratio 1.00 – 500.00, ∞ 0 127 Table #32
6 Side Chain EQ Switch Off, On 0 1
7 Side Chain EQ Q 0.100 – 10.00 0 126 Table #33
8 Side Chain EQ
Frequency
11.89Hz – 17.78kHz 0 127 Table #34
9 Side Chain EQ Gain -30.0dB – 0.0dB – +30.0dB 0 120
10 Dry/Wet D63>W – D=W – D<W63 1 127
11 Output Level -20.0dB – 0.0dB – +40.0dB 0 120
12 Make Up Gain -20.0dB – 0.0dB – +40.0dB 0 120
13 Post-comp HPF Off, 1.04Hz – 80.35Hz 0 127 Table #35
14 Clipper Off, 1 – 100 0 100
15 Clipper Source Dry+Wet, Wet 0 1
16
No. Parameter Display Min Max Table Control
1 Input Level -∞dB, -138.0dB – 0.00dB 0 200 Table #36
2 Output Level -∞dB, -138.0dB – 0.00dB 0 200 Table #36
3 Ratio 2, 4, 8, 12, 20 0 4
4 Attack 0.022ms – 50.40ms 0 200 Table #37
5 Release 10.88ms – 544.22ms 0 200 Table #38
6
7
8
9
10
11
12
13
14
15
16
No. Parameter Display Min Max Table Control
1 Attack 1ms – 40ms 0 19 Table #18
2 Release 10ms – 680ms 0 15 Table #19
3 Threshold -48dB – -6dB 79 121
4 Ratio 1.0 – 20.0 0 7 Table #20
5 Output Level 0 – 127 0 127
6
7
8
9
10
11
12
13
14
15
16
No. Parameter Display Min Max Table Control
1 Type Normal, Low, Mid, High,
Low/High, Low/Mid, Mid/
High, Full Bit, Wild, Attacky,
Low End, Hard, Basic
012
2 Threshold Offset -32 – 0 – +32 32 96 
3 Low Gain Offset -63 – 0 – +63 1 127
4 Mid Gain Offset -63 – 0 – +63 1 127
5 High Gain Offset -63 – 0 – +63 1 127
6
7
8
9
10
11
12
13
14
15
16
No. Parameter Display Min Max Table Control
1 Attack 1ms – 40ms 0 19 Table #18
2 Release 10ms – 680ms 0 15 Table #19
3 Threshold -72dB – -30dB 55 97
4 Output Level 0 – 127 0 127
5
6
7
8
9
10
11
12
13
14
15
16
EQ/ENHANCER
No. Parameter Display Min Max Table Control
1 EQ Low Gain -12dB – 0dB – +12dB 52 76
2 EQ Mid Frequency 100Hz – 16kHz 14 58 Table #3
3 EQ Mid Gain -12dB – 0dB – +12dB 52 76
4 EQ Mid Width 0.1 – 12.0 1 120
5 EQ High Gain -12dB – 0dB – +12dB 52 76
6 EQ Low Frequency 50Hz – 2.0kHz 8 40 Table #3
7 EQ High Frequency 500Hz – 16kHz 28 58 Table #3
8
9
10
11
12
13
14
15 Input Mode Mono, Stereo 0 1
16
No. Parameter Display Min Max Table Control
1 EQ Low Frequency 32Hz – 2.0kHz 4 40 Table #3
2 EQ Low Gain -12dB – 0dB – +12dB 52 76
3 EQ High Frequency 500Hz – 16kHz 28 58 Table #3
4 EQ High Gain -12dB – 0dB – +12dB 52 76
5
6
7
8
9
10
11
12
13
14
15
16