User's Manual

En 121
Speaker
Configures the speaker settings manually.
X
Default settings are underlined.
■ Setting Pattern
Registers two speaker setting patterns and switches between them.
When you configure the following speaker settings, the settings will be memorized in the
selected pattern.
• Configuration
• Distance
• Level
•Parametric EQ
•YPAO Result
Settings
Pattern1
, Pattern2
X
• The setting pattern currently selected is shown at the center of the diagram on the right side of the screen.
• This function is useful when you want to save certain settings according to the varying conditions of your
listening environment. For example, if you want to switch the settings when curtains are open or closed, you
can save the settings suited for each condition and switch between them.
■ Setting Data Copy
Copies the “Setting Pattern” parameters in the specified direction.
Choices
■ Configuration
Configures the output characteristics of the speakers.
X
• When you configure the speaker size, select “Large” if the woofer diameter of your speaker is 16 cm (6-1/4”) or
larger or “Small” if it is smaller than 16 cm (6-1/4”) as a guide.
• When the speaker size is set to “Small”, you can configure the “Crossover”. Frequency sounds lower than the
specified value will be output from the subwoofer and higher will be output from the corresponding speakers.
Front
Selects the size of the front speakers.
Settings
X
“Front” is automatically set to “Large” when both “Subwoofer 1” and “Subwoofer 2” are set to “None”.
Pattern1 ▶ 2 Copies the “Pattern1” parameters to “Pattern2”.
Pattern2 ▶ 1 Copies the “Pattern2” parameters to “Pattern1”.
Large
Select this option for large speakers.
The front speakers will produce all of the front channel frequency components.
Small
Select this option for small speakers.
The subwoofer will produce front channel low-frequency components lower than
the specified crossover frequency (default: 80 Hz).