User Manual
Table Of Contents
- Cover
- Contents
- Introduction
- Controls and Connectors
- Panel Operations
- Basic Operations
- Screen Structure
- Operations that can be Performed from the Panel
- Alert Messages
- HOME Screen
- METER Screen
- SETTING Screen
- UTILITY Screen
- MENU Screen
- SIGNAL PATH Screen
- SIGNAL PATH Block Diagrams
- Recalling library settings (Speaker Processor only)
- Slot Input Router
- Input On/Off
- 4x4 Matrix Mixer
- 8Band Input EQ
- Input Delay
- Oscillator Mix
- X-Over Input Level (Speaker Processor)
- X-Over Polarity (Speaker Processor)
- X-Over (Speaker Processor)
- Output Delay (Speaker Processor)
- 6Band Output EQ (Speaker Processor)
- Output Level (Speaker Processor)
- Mute On/Off (Speaker Processor)
- Limiter (Speaker Processor)
- Output Router
- SCENE Screen
- Initializing the internal memory
- System Connection Examples
- Connecting External Controllers and Analog Devices
- Adjusting the Input/Output Levels
- Appendix
TX6n/5n/4n Reference Manual
10
Controls and Connectors
■ Removing and installing a card
To remove and install a card, proceed as follows.
1. Make sure that the power of the TXn is turned off.
2. Loosen the screws that fasten the slot, and remove the installed card.
Keep the removed card in a safe place.
3. Align the two edges of the card to be installed with the guide rails inside the slot, and insert the card into the
slot.
Push the card all the way into the slot so that the contacts of the card are correctly mated with the connector inside the slot.
4. Fasten the card using the screws attached to the card.
Be aware that malfunctions or faulty operation may occur if the card is not fastened.
•You must turn off the amplifier’s power switch before removing and installing a card. Otherwise, malfunctions or electric
shock may occur.
Guide rail
CAUTION