User Manual
CZR series Owner’s Manual 3
NOTICE
To avoid the possibility of malfunction/damage to the product, 
or damage to other property, follow the notices below.
 Handling and maintenance
• Do not expose the product to excessive dust or vibration, 
or extreme cold or heat (such as in direct sunlight, near a 
heater, or in a car during the day), in order to prevent the 
possibility of panel disfiguration, unstable operation, or 
damage to the internal components.
• Do not place the speaker face down with the grille 
attached, as deformation of the grille may result.
• When placing the speaker face down, always place it on a 
flat surface.
• Do not touch the speaker driver unit.
• Be sure to observe the amplifier’s rated load impedance 
(see page 7), particularly when connecting speakers in 
parallel. Connecting an impedance load outside the ampli-
fier's rated range can damage the amplifier.
• Protection Circuit
This speaker system has an internal protection circuit that 
shuts off the speaker unit when an excessive input signal is 
applied. If the speaker unit emits no sound, reduce the vol-
ume level of the amplifier immediately. The sound will 
return automatically in several seconds.
• Air blowing out of the bass reflex ports is normal, and often 
occurs when the speaker is handling program material 
with heavy bass content.
• During extreme changes in temperature or humidity, con-
densation may occur and water may collect on the surface 
of the product. If water is left, the wooden parts may 
absorb the water and be damaged. Make sure to wipe any 
water off immediately with a soft cloth.
 Connectors
• Use only Neutrik NL4 plugs for connecting speakON con-
nectors.
Information
 About this manual
• The illustrations as shown in this manual are for instruc-
tional purposes only.
• The company names and product names in this manual 
are the trademarks or registered trademarks of their 
respective companies.
 About disposal
• This product contains recyclable components. When dis-
posing of this product, please contact the appropriate 
local authorities.










