User Manual

Dante-MY16-AUD2 Getting Started Guide - 11 -
Getting Further Information
Important Notices
Reading the Dante-MY16-AUD2 User Guide, Dante Virtual Soundcard User Guide and Dante Controller User
Guide is recommended, as they contain more detailed information about configuring and using Dante.
These documents are available from the Dante-MY16-AUD2 pages at the Yamaha Pro Audio website:
www.yamahaproaudio.com
TO AVOID COMMON CONFIGURATION ERRORS, PLEASE READ THE FOLLOWING NOTICES.
Unsupported Network Configurations
1. Do not connect Dante Primary and Secondary redundant networks to the same switch.
2. When using Dante redundancy with any Dante-enabled device, including Dante-MY16-AUD2 cards, two
separate networks must be used. You CANNOT connect any secondary network connections to a switch
used for the primary network, or any primary network connections to a switch used for the secondary
network.
3. The use of 100 Mbps network with Dante-MY16-AUD2 cards is NOT SUPPORTED. You must only connect
Dante-MY16-AUD2 cards to Gigabit interfaces:
• Gigabit switches, or a Gigabit port on an Ethernet switch
• Gigabit network interface on a PC or Mac
• Other Dante-enabled devices with Gigabit interfaces
Sample Rate Configuration
You will need to use the Dante Controller to view and set Dante-MY16-AUD2 sample rate. Please read the Dante-
MY16-AUD2 and Dante Controller User Guides for instructions.
Some important points:
• Make sure all Dante-MY16-AUD2 cards installed in the same Yamaha equipment are set to the same
sample rate.
Primary Secondary
Primary Secondary