User Manual

Dante-MY16-AUD2 Getting Started Guide - 7 -
Connection Examples (contd.)
Example 2: Connect your PC or other Dante-enabled equipment and Dante-MY16-AUD2 card (or multiple cards)
using a Gigabit switch:
Example 3: Connect multiple Dante-MY16-AUD2 cards to each other in a daisy chain configuration. Requires that
up-stream Dante-MY16-AUD2 cards are configured (using Dante Controller) to use Switched mode.
For glitch-free Dante Redundancy: Connect Dante Controller, your Dante-MY16-AUD2 cards and other
redundant Dante-enabled audio equipment using duplicate Gigabit switches and Ethernet cables to protect
against possible cable or switch failures. Connect Dante Virtual Soundcard and other non-redundant Dante-
enabled audio equipment to the Primary Dante Network. Requires that the Dante-MY16-AUD2 cards are
configured to use Redundant mode.
Gigabit Switch
Primary
Gigabit Switch
Dante-enabled devices
without redundancy support
Dante Controller
Dante Virtual Soundcard
Primary port
Primary Network Secondary Network
Secondary port
Secondary
Gigabit Switch
Note: Dante Virtual Soundcard does not support Dante Redundancy, or connect to Dante secondary networks.
Dante Redundancy can be set up and used between any supporting Dante-enabled audio equipment, including
Dante-MY16-AUD2 cards.
Gigabit Switch