User Manual
Table Of Contents
- System Requirements
- Installation
- Installing Speaker Data
- Uninstalling
- Table of Contents
- 1. Y-S3 General Operation
- 2. Constructing the Room Shape & Audience Area
- 3. Editing Project Properties
- 4. Placing Speakers
- 5. Adjusting Speaker Parameters
- 5-1. Speaker Arrays
- 5-2. Distributed Speakers
- 6. Displaying Calculation Results
- 7. Simulation Results Report
- 8. Exporting Configurations in DME Designer Format
- 9. Other Functions
- 10. General Theory
Yamaha Sound System Simulator Y-S
3
Owner’s Manual V3.1
21
• Others
Unit
Select “Imperial” (feet and Fahrenheit) or “Metric” (meter and Celsius) for units of length and temperature.
Listen
Enter the coordinates of the principal performer or person speaking. These figures should be absolute coordinates.
You should take height into account if you are using the equipment on a stage. For example, using a sound source
1.5 m for the stage floor, when the height of the stage floor is 0.8 m from the ground gives a total height of 2.3 m. Y-
S3 refers to the origin point when creating auralization data. The auralization data is calculated using head-related
transfer functions (HRTF) by assuming that the listener is facing the Origin Point. See chapter 6 for how to create
auralization data.
Contour Display
Check the “Wall” checkbox to show the walls in Aspect View. The height of the wall is fixed at 5 m. You may check any
unnecessary radiation onto the walls by checking the contour shown on the walls. Note that Y-S3 does not calculate
the reflections from the walls even if this option is selected.
Report Page Size
Set the size of the page to print. You can select letter size or A4 paper.