User Manual
Table Of Contents
- System Requirements
- Installation
- Installing Speaker Data
- Uninstalling
- Table of Contents
- 1. Y-S3 General Operation
- 2. Constructing the Room Shape & Audience Area
- 3. Editing Project Properties
- 4. Placing Speakers
- 5. Adjusting Speaker Parameters
- 5-1. Speaker Arrays
- 5-2. Distributed Speakers
- 6. Displaying Calculation Results
- 7. Simulation Results Report
- 8. Exporting Configurations in DME Designer Format
- 9. Other Functions
- 10. General Theory
Yamaha Sound System Simulator Y-S
3
Owner’s Manual V3.1
53
Click to select the dry audio source to be convolved with the calculated response. The dry source must
be in 44.1 kHz, 16-bit WAV (PCM) and stereo format. The maximum data size is 5 minutes (about 50 MB) in this format.
Click to play the calculated audio sound. Click to stop playing, to pause playing. You can also set
the playback volume with the slider. You can adjust a level difference when comparing responses from different
calculation conditions.
Click to save the sound as heard at the receiving point. Y-S
3
stores audio data in 44.1 kHz, 16-bit WAV (PCM) and
stereo format.
You can set the “HRTF” checkbox to “on” to listen to the sound with HRTF (head-related transfer functions) applied.
You can apply a directional effect to so that the sound appears to be coming from a predefined direction.