Operation Manual

30
Chapter 6 Related Information
Notes on the Passcode Setting
To prevent others from controlling your Disklavier with the Disklavier Controller, you can set
the passcode on your Disklavier.
Default setting
No passcode is set as default, which means any Disklavier Controller can control your
Disklavier.
How to set the passcode
The passcode can be set in the passcode setting screen of your Disklavier.
For Disklavier Mark IV users:
You can access this screen by tapping
on
, then on . Refer
to the Advanced Operating Manual for
more information.
For Disklavier E3 and Disklavier
Control Unit DKC-850 users:
You can access this screen by pressing
[SETUP] on the remote control, then
selecting “Passcode.” Refer to the
Operation Manual for more information.
Set the 4-digit number as the passcode.
You can control your Disklavier with the Disklavier Controller by entering the passcode set in
this screen (see page 6).
Forgot passcode?
Delete or reset the passcode in the screen above.