Owner`s manual

25
To send a single USER AREA patch (data) with
the Bulk Out operation.
After pressing the [SPRING] button, select the patch
number you want to send with the bulk out. Just as
in selecting a patch number in the Play Mode, use
the [UP]/[DOWN] buttons or the foot switches to
select the patch.
After selecting a patch, press the [STORE] button
to carry out the MIDI Bulk Out operation with a single
patch.
* After transmitting the data the device will return to the previ-
ous condition, ready to select another patch number.
● About the MIDI Bulk In
This operation is used to return data stored in an
external MIDI device such as the YAMAHA MDF3,
etc., to the DG-Stomp.
Use a MIDI cable to connect the MIDI OUT jack on
the external MIDI device to the DG-Stomp’s MIDI
IN jack.
When Bulk Out data is sent from the external de-
vice, the DG-Stomp will receive the bulk data.
* Use the DG-Stomp’s Play Mode to receive MIDI Bulk In data.
When the MIDI Bulk In is carried out, the con-
tents of the patches in the USER AREA will
be rewritten.
Please make sure any important data is saved
before carrying out the MIDI Bulk In opera-
tion.
■ External Control Settings
Just as in the [External Control Settings] section on
page 21, these settings are used to control the DG-
Stomp’s volume, tone and effect parameters from a
foot controller that is connected to the EXP. PEDAL
jack or a MIDI device that is connected to the MIDI
In jack.
Press the [UTILITY] button then set the Amp Select
switch to DRIVE1 (“CtL” will appear on the dis-
play).
● External Control’s Operating Mode Setting
Press the [COMP] button and use the [UP]/[DOWN]
buttons to select an Operating Mode for the exter-
nal control.
• GLb : The external control setting in the Utility
Mode is always available.
• PrG : The external control setting that is set in
the patch is available.
• oFF : The external control is always OFF.
● Set the External Control Number
Press the [CHORUS] button and use the [UP]/
[DOWN] buttons to set a control number (1-8).
* Refer to [External Control Settings] (page 21)
● Set the External Controller
Press the [FLANGER] button and use the [UP]/
[DOWN] buttons to select the type of controller (EP,
1-31, 64-95).
* Refer to [External Control Settings] (page 21)
● Set the Parameter to be Controlled
Press the [PHASER] button and use the [UP]/
[DOWN] buttons to select the parameter to be con-
trolled (UUH-).
* Refer to [External Control Settings] (page 21)
● Set the Parameter’s Minimum Value
Press the [ROTARY] button and use the [UP]/
[DOWN] buttons to set the parameter’s minimum
value (the parameter’s value when the controller is
set to its minimum: 0.0-10.0).
* Refer to [External Control Settings] (page 21)
● Set the Parameter’s Maximum Value
Press the [TREMOLO] button and use the [UP]/
[DOWN] buttons to set the parameter’s maximum
value (the parameter’s value when the controller is
set to its maximum: 0.0-10.0).
* Refer to [External Control Settings] (page 21)
Utility Mode