Owner`s manual

27
■ Wah Pedal Settings
These settings are available when the Wah Pedal
function (“UUH”) is selected as the controller in the
External Control settings.
Press the [UTILITY] button then set the amp select
switch to CRUNCH1 (“UUH” will appear on the dis-
play).
● Set the Low Frequency of the Wah Pedal
Sets the low frequency in the wah pedal’s frequency
range.
Press the [COMP] button and use the [UP]/[DOWN]
buttons to set the frequency (150-500:Hz).
● Set the High Frequency of the Wah Pedal
Sets the high frequency in the wah pedal’s frequency
range.
Press the [CHORUS] button and use the [UP]/
[DOWN] buttons to set the frequency (1.50-
5.00:kHz).
● Set the Wah Pedal “Q”
Sets the frequency curve of the wah pedal.
Press the [FLANGER] button and use the [UP]/
[DOWN] buttons to select a curve (1.00-5.00).
■ The Speaker Simulator
Press the [UTILITY] button then set the amp select
switch to CRUNCH2. The current setting will appear
on the display.
Use the [UP]/[DOWN] buttons to select a speaker
simulator mode.
• GLb : The speaker simulator is always ON.
• PrG : The speaker simulator is switched ON/
OFF according to the patch setting.
• oFF : The speaker simulator is always OFF
Utility Mode
■ Preamp Circuit ON/OFF Settings
When the DG-Stomp’s preamp circuit is not used, it
is possible to use the DG-Stomp as an effector or a
MIDI foot controller.
Press the [UTILITY] button then set the amp select
switch to CLEAN1.
Use the [UP]/[DOWN] buttons to set the preamp cir-
cuit ON/OFF.
• on : The preamp circuit is active (in use)
• oFF : The preamp circuit is inactive (not in use)