User Manual

Connecting a Microphone and Singing Along with Your Performance
DGX-660 Owner’s Manual
71
Reference
MIC SETTING 1 display
* The settings marked with * (asterisk) will be maintained even if
you turn off the power.
MIC SETTING 2 display
4
Press the [EXECUTE] button to save the
settings.
The save confirmation message will appear on the
display.
5
Press the [+] (YES) button to actually
save the settings.
6
Press the [EXIT] button to exit from the
MIC SETTING display.
Calling Up the Microphone Set-
tings Saved to USER
1
Press the [MIC SETTING] button once or
twice to call up the MIC SETTING 1 dis-
play.
2
Select “PRESET” by using the CATE-
GORY [r] or [f] button, then select
“USER” by rotating the dial.
MIC ON/
OFF*
Turns the microphone sound on or off.
INPUT
LEVEL
Indicates the input level.
PRESET*
Calls up one of the preset settings (STANDARD,
BRIGHTER and LOUDER) or the settings saved
as USER.
VOLUME
Determines the output volume of the microphone
sound.
PA N
Determines the stereo pan position of the micro-
phone sound.
EFFECT
SEND
REVERB
Determines the depth of the reverb
effect applied to the microphone
sound.
CHORUS
Determines the depth of the chorus
effect applied to the microphone
sound.
RESET
Resets the values of parameters on MIC SET-
TING 1 and 2 displays to the default when one of
the preset type is selected. When “USER” is
selected, this resets them to the latest saved
value.
NOISE
GATE
ON/OFF
Turns the Noise Gate on or off. This
effect mutes the input signal when
the input signal falls below a speci-
fied level.
TH.
(Threshold)
Adjusts the input level at which the
gate begins to open.
COMPRES-
SOR
ON/OFF
Turns the Compressor on or off. This
effect holds down the output when
the input signal from the micro-
phone exceeds a specified level.
TH.
(Threshold)
Adjusts the input level above which
the Compressor is applied.
RATIO
Adjusts the compression ratio.
Higher ratios result in a more com-
pressed sound, making soft sounds
louder, but reducing the dynamic
range.
OUT Adjusts the final output level.
3 BAND EQ
EQ (Equalizer) is a processor that divides the fre-
quency spectrum into multiple bands which can
be boosted or cut as required to tailor the overall
frequency response.
Hz
Adjusts the center frequency of the
corresponding band.
dB
Boosts or cuts the level of the corre-
sponding band by up to 12 dB.
• The settings here are lost if you turn off the power without
executing the Save operation (See below).
NOTICE
• The Save operation will delete the previously saved
USER data.
• To cancel this operation, press the [-] (NO) button.
NOTICE
NOTE