User Manual

Keyboard Stand Assembly
DGX-660 Owner’s Manual
13
Setting Up
2
Attach the metal brackets.
Attach the metal brackets w to the top of the side
boards, using the screws
e as shown.
3
Attach the stand bases.
Insert the joint connectors q into the side boards
as shown. The joint connectors have been installed
properly if you can see the screw head on the con-
nector.
Attach the “L” (Left) and “R” (Right) stand bases
to the bottom of the side boards, using the screws
r. “L” (Left) and “R” (Right) are marked on the
upper surfaces of the stand bases. If you have trou-
ble fastening the screws, use a screwdriver to
rotate the joint connectors so that the connector
holes are aligned with the screw holes on the stand
bases.
2
LR
e 3 x 8 mm
roundhead
screws
w Metal bracket
(C)
w Metal bracket
(A)
w Metal bracket
(B)
w Metal bracket
(C)
e 3 x 8 mm
roundhead
screws
3
q Joint
connectors
r 6 x 70 mm
roundhead screws
“L”
“R”
• If you put the connectors in wrong direction and want to
take them out, tap around the holes on the boards.
NOTE