User Manual
Table Of Contents
- 01_YH773B0_dkven_st_pro_om_en_fr_de_es_it_c1
- 02_1_YH773B0_dkven_st_pro_om_pre
- 02_2_YH773B0_dkven_st_pro_om_frontmatter
- 03_YH773B0_dkven_st_pro_om_en_body
- 04_YH773B0_dkven_st_pro_om_appendix
- dkven_st_pro_om_en_YH773A0 39
- dkven_st_pro_om_en_YH773A0 40
- dkven_st_pro_om_en_YH773A0 41
- dkven_st_pro_om_en_YH773A0 42
- dkven_st_pro_om_en_YH773A0 43
- dkven_st_pro_om_en_YH773A0 44
- dkven_st_pro_om_en_YH773A0 45
- dkven_st_pro_om_en_YH773A0 46
- dkven_st_pro_om_en_YH773A0 47
- dkven_st_pro_om_en_YH773A0 48
- dkven_st_pro_om_en_YH773A0 49
- dkven_st_pro_om_en_YH773A0 50
- dkven_st_pro_om_en_YH773A0 51
- dkven_st_pro_om_en_YH773A0 52
- dkven_st_pro_om_en_YH773A0 53
- dkven_st_pro_om_en_YH773A0 54
- dkven_st_pro_om_en_YH773A0 55
- 05_YH773B0_dkven_st_pro_om_en_fr_de_es_it_c4
Getting Started
2
Chapter
15
Note:
To check whether your wireless
router (access point) supports WPS,
refer to the owner’s manual supplied
with your wireless router (access
point).
If your wireless router (access point) supports WPS, you can easily
connect the Disklavier to a network just by following the procedures below,
without making any additional settings, such as entering a password.
Press the POWER button to turn the power off.
Connect the USB wireless LAN adaptor (UD-WL01) to the
USB port on the rear of the switch box.
Check that the WLAN switch on the rear of the switch box
is set to “RT.”
Note:
On powering up, the display may
indicate an error message that
flashes in red, reading “The wireless
router (access point) is not found.”
However, you can safely ignore the
error, and proceed to step 5.
Press the POWER button to turn the power on.
Hold down the WPS button on the USB wireless LAN
adaptor (UD-WL01) for at least five seconds.
The LED lamp on the USB wireless LAN adaptor (UD-WL01)
flashes every 0.5 seconds.
Wireless Network Connection by WPS
1
2
LED lamp
WPS button
WLAN switch
3
4
5