manual

Enhancing the Disklavier by Hooking Up Other Devices
English
12
Chapter
113
You can select the kind of the incoming/going out audio signals. The
following options should be set up in advance.
OMNI IN
Selects the appropriate option to match the incoming data input to the
OMNI (SYNC) IN jacks.
Auto Detect:
Select this when you make the Disklavier control unit detect the
input signal automatically.
Audio: Select this when you play back an audio software on the
connected CD player, etc. and reproduce the sound from
optional monitor speakers.
OFF: Select this when you cancel the data reception from the OMNI
(SYNC) IN jacks.
OMNI IN Vol
Adjust the volume of the incoming audio signals to the OMNI (SYNC) IN
jacks. The volume can be set in a range of 000 to 127.
OMNI OUT
Selects the desired data to be output from the OMNI (SYNC) OUT jacks.
Output: Select this when you output the same audio signals as the
ones for the OUTPUT jacks.
SYNC: Select this when you output the SMPTE signal used for video
synchronization playback.
OFF: Select this when you cancel the data transmission from the
OMNI (SYNC) OUT jacks.
OMNI OUT Vol
Note:
“M-Volume” is the next increment
on the OMNI OUT Vol setting
above 127.
Adjust the volume of the outgoing audio signals to the OMNI (SYNC) OUT
jacks. The volume can be set in a range of 000 to 127, or to “M-Volume.”
When you set to “M-Volume”, the OMNI OUT volume works with the main
volume.
ANALOG MIDI IN Vol
Adjust the volume of the incoming audio signals to the ANALOG MIDI IN
jacks. The volume can be set in a range of 000 to 127.
Setting the Disklavier Control Unit for Audio Data Reception/
Transmission
[SETUP] “AudioI/O”
000
127
M-Volume
OMNI OUT
Vol parameter
~
[–/NO]
[+/YES]