manual

Other Settings
13
Chapter
126
Note:
These settings are not required for
the use of the remote control of this
unit. In case of using an external
remote controller, refer to the user’s
guide for that remote controller.
You can enter the 4-digit passcode to prevent unauthorized access from
the commercially available external remote controller, or you can also set
the MAC address of the external remote controller to allow it to access
your Disklavier without entering the passcode.
Note:
If changes are inappropriately made
for these settings, the external
remote controller may not function
properly. In such cases, enter
“####” to reset the passcode setting.
■ Setting the Passcode
Press [SETUP] on the remote control.
The setup menu screen appears.
Select “Passcode” with the cursor buttons ([ ] [ ] [ ]
[ ]), then press [ENTER].
The passcode setting screen appears.
Note:
You can also use [+/YES] and
[–/NO] on the remote control, or the
dial on the front panel to enter the
code.
Enter the 4-digit code with the number keypad.
You can move the cursor left and right with the cursor buttons
(
[] []).
If you want to set the MAC address continuously, see “Setting the
MAC Address” and follow the instruction.
Press [ENTER] to complete the operation.
Press [SETUP] to exit from the setup menu.
Setting the Passcode to Prevent Unauthorized Access
[SETUP] “Passcode”
1
*TimerPlay *AudioI/O
*M-Tune*MIDI
=SETUP MENU= (1/3)]
2
*Passcode *Reset
=SETUP MENU= _(3/3)
>Passcode=####
=Passcode= ]-+
3
>Passcode=1234
>MAdr1=##:##:##:##:##:##
=Passcode= _?-+
4
5