manual

Other Settings
13
Chapter
132
Note:
For this operation you have to insert
the CD-ROM or USB flash memory
in which the update program is
saved or download update program
via Internet, and shut down the
Disklavier control unit.
You can update the Disklavier control unit firmware using update program
(saved on the CD-ROM or USB flash memory, or downloaded via Internet).
You can download the update program from the following website:
http://download.yamaha.com/
Note:
Depending on the version or
specification of the Disklavier, the
actual indications for the version
and module names may differ from
ones depicted here.
Make sure that Disklavier control unit is shut down.
Holding [PLAY/PAUSE] on the front panel, press [ON/OFF].
The current version information of each module appears one after
the other.
Make sure that the update program is prepared, then press
[ENTER] on the front panel.
The starting screen appears.
Press [ENTER] on the front panel again.
After a while, the update confirmation message of each module
appears.
Updating the Disklavier Control Unit
Shut down the Disklavier control unit [PLAY/PAUSE] and [ON/OFF]
1
2
Hold
+
CTRL system v2.50
(ENT)*UPDATE
3
4
v2.50
(PLAY,STOP)MC -SURE?
v3.10]