manual

Getting Started
English
2
Chapter
9
Turn on your piano, and reset settings on your control unit
to its factory default.
For details on setting, refer to your piano’s owner’s manual.
Turn off your piano, and disconnect the power cable from
the AC wall outlet.
Note:
The location of the TO CONTROL
CABLE FOR PIANO connector
varies depending on the piano
model.
Disconnect the control cable from the TO CONTROL
CABLE FOR PIANO connector on the rear panel of your
control unit.
Loosen the two screws attached to the connector by the
screwdriver.
Attention:
The Disklavier control unit does not
work properly if the control cable is
connected directly to it. Use the
supplied conversion cable to
connect your piano and the
Disklavier control unit.
Connect the supplied conversion cable to the control
cable disconnected in step 2.
Tighten the two screws attached to the connector by the
screwdriver.
Connect the supplied conversion cable to the TO PIANO
connector on the rear panel of the Disklavier control unit.
Tighten the two screws attached to the connector by the
screwdriver.

See Chapter 2 “Getting Started –
Connecting Monitor Speakers” on
page 12.
Connect monitor speakers to the OUTPUT jacks on the
rear panel of the Disklavier control unit.
Connect the supplied AC adaptor to the DC-IN 12V
connector on the rear panel of the Disklavier control unit.
Connect the supplied power cable to the AC adaptor.
Connect the power cable extended from your piano and
the AC adaptor to the AC wall outlet.

See Chapter 2 “Getting Started –
Setting the Type of Your Piano” on
page 15.
The connection completed.
Turn on the Disklavier control unit, and set the piano type.
Important
• Be sure to backup the data on your control unit to the floppy disk before connecting.
• Please keep the disconnected control unit for future maintenance.
1
2
3
4
5
6
7
8
9