Specifications

Getting Started
English
2
Chapter
11
Turn off your piano, and disconnect the power cable from
the AC wall outlet.
Note:
The location of the MIDI IN
terminal varies depending on the
piano model.
Connect the MIDI IN terminal of your control unit to the
MIDI OUT terminal of the rear panel of the Disklavier
control unit with the supplied MIDI cable.
Note:
The location of the MIDI OUT
terminal varies depending on the
piano model.
Connect the MIDI OUT terminal of your control unit to the
MIDI IN terminal of the rear panel of the Disklavier control
unit with the supplied MIDI cable.
)
See Chapter 2 “Getting Started –
Connecting Monitor Speakers” on
page 12.
Connect monitor speakers to the OUTPUT jack on the rear
panel of the Disklavier control unit.
Connect the supplied AC adaptor to the DC-IN 12V
connector on the rear panel of the Disklavier control unit.
Connect the supplied power cable to the AC adaptor.
Connect the power cable extended from your piano and
the AC adaptor to the AC wall outlet.
Note:
For the location of the remote
control sensor, refer to your piano’s
owner’s manual.
Place the remote control sensor shielding sticker over the
remote control sensor of the control unit of your piano.
The remote control supplied with the Disklavier control unit will also
operate the control unit of your piano.
In order to prevent this, be sure to place the remote control sensor
shielding sticker.
Turn on your piano, and make the MIDI data transmission/
reception settings on the control unit of your piano.
Make the settings as follows. For details on setting, refer to your
piano’s owner’s manual.
Settings
)
See Chapter 2 “Getting Started –
Setting the Type of Your Piano” on
page 15.
The connection completed.
Turn on the Disklavier control unit, and set the piano type.
1
2
3
4
5
6
7
MIDI IN CH HP
MIDI IN DELAY IN (500ms)
MIDI OUT KBD OUT
OUT CH HP
8
9