Installation guide

4
Chapter 1—Getting Started
Studio Manager for DM2000/02R96—Installation Guide
DM2000/02R96 Hookup
The following illustration shows the three hookup methods that can be used to connect the
DM2000/02R96 to your computer: serial, USB, or MIDI.
Configuring the DM2000/02R96
On the DM2000/02R96, use the DISPLAY ACCESS [SETUP] button to locate the
MIDI/TO HOST Setup page. Under “Studio Manager,” select a port and assign an ID to the
DM2000/02R96. If you are using a serial connection, set the TO HOST SERIAL options as
necessary (i.e., “PC-2” for a Windows PC, or “Mac” for a Macintosh computer). Refer to the
DM2000 Owner's Manual or 02R96 Owner's Manual for more information.
Note: Before you connect to serial or MIDI ports, turn off the DM2000/02R96 and your
computer.
USB cable
(Yamaha CCJ-Mac
or equivalent)
(Yamaha CCJ-PC2
or equivalent)
USB port
Serial cable
Mac serial port
PC serial port
DM2000/02R96 rear panel Mac or PC
Serial1.
USB
MIDI
MIDI interface
MIDI cables
2.
3.