Owner's Manual

Using Studio Manager
Windows
Getting Started
Keyboard Shortcuts
Index
30
Studio Manager for V2 DM2000 Editor—Owner’s Manual
Using SM Windows
F Effect parameter section
This section contains the various effects controls, buttons, and displays. Its layout depends on the
selected effect type.
G [MIX BALANCE] control
This control enables you to adjust the balance between the wet and dry signals. When set to 0, only the
dry signal is heard. When set to 100, only the wet signal is heard.
H [BYPASS] button
This button is used to bypass the currently selected effects processor.
Meter Window
The Meter window displays the Input, Output, Effect, and Stereo Out meters. To open the Meter win-
dow, choose [Meter] from the [Windows] menu. This window consists of five display pages. You can
access these pages by clicking the tabs along the top of the window.
The layout of the Meter window pages is the same regardless of the page selected. (The Master page is
shown below.)
A Meter mode
You can select the type of meters to be displayed from the following options:
GATE GR: The meters indicate the amount of gain reduction being applied by the channel Gate.
COMP GR: The meters indicate the amount of gain reduction being applied by the channel
Compressor.
LEVEL: The meters indicate the channel level.
B POSITION parameter
This parameter, available only when Meter mode is set to Level, enables you to select the metering
position in the signal path.
Page Function
CH1-96 page This page displays the Input Channel 1-96 meters (12 segments).
MASTER page
This page displays the Bus 1-8, Aux 1-12, Matrix 1-4, and Stereo meters (12 seg-
ments).
Effects 1-8 page
This page displays the Channel 1 & 2 input/output meters (12 segments) for Effects
1-8.
Effects 1-2 page
This page displays the Channels 1-8 input/output meters (12 segments) of Surround
Effects modules.
Stereo page This page displays a bar graph (32 segments) of signal levels output to the Stereo Out.
A 2 3