Owner's Manual

86 Chapter 9—Bus Outs

DM2000—Owner’s Manual

Muting Bus Outs (ON/OFF)

Bus Outs can be muted by using the channel strip [ON] buttons.

1 Press the LAYER [MASTER] button to select the Master Layer.

2 Use channel strip [ON] buttons 1–8 to mute the Bus Outs.

The [ON] button indicators of Bus Outs that are on light up.

Grouping Master Mutes (ON/OFF)

Bus Out Mutes can be grouped with the Mutes of other Output Channels. See “Grouping

Output Channel Mutes (ON/OFF)” on page 123 for more information.

Setting Bus Out Levels

Bus Out levels can be set as follows.

1 Press the LAYER [MASTER] button to select the Master Layer.

2 Press the FADER MODE [FADER] button to select Fader mode.

3 Use faders 1–8 to set the Bus Out levels.

Refer to the legend on the right side of the faders when setting Bus Out levels.

Grouping Master Faders

Bus Out faders can be grouped with the faders of other Output Channels. See “Grouping

Output Channel Faders” on page 122 for more information.

Sending Bus Outs to Matrix Sends

Bus Out signals can be sent to the Matrix Sends. See “Matrix Sends” on page 97 for more

information.

Delaying Bus Outs

Each Bus Out features a Delay function. See “Delaying Channel Signals” on page 117 for

more information.

Inserting GEQs

Internal GEQs can be inserted into the Bus Outs. See “About the GEQs” on page 155 for

more information.

Soloing Bus Outs

Bus Outs can be soloed. See page 118 for more information.

Pairing Bus Outs

Bus Outs can be paired for stereo operation. See “Pairing Channels” on page 120 for more

information.