Owner's Manual

122 Chapter 12—Common Channel Functions
DM2000—Owner’s Manual
When a Surround mode other than Stereo is selected, Aux Sends can be set to follow the
same Input Channel Surround Pan that applies to the Bus Outs, which is useful for feeding
Surround channel signals to external effects processors. This is turned on and off by using
the F.S buttons that appear below the Aux Send Pair buttons. When a pair of Aux Sends are
set to follow Surround Pan, their Aux Send Pair button is unavailable, and their Aux Pan
parameters (see page 94) are unavailable.
Grouping Output Channel Faders
The Bus Out, Aux Send, Matrix Send, and Stereo Out faders can be grouped, allowing you
to control the level of several Output Channels simultaneously. There are four Output
Channel Fader groups: Q, R, S, and T.
1 Use the DISPLAY ACCESS [GROUP] button to locate the Output Fader Group
page.
2 Press the LAYER [MASTER] button.
3 Use the Up/Down cursor buttons to select Fader groups Q–T.
The selected group is highlighted by a flashing cursor box.
4 Use the [SEL] buttons to add and remove Output Channel faders to and from
the selected group.
When an Output Channel is added to a group, its [SEL] button indicator lights up.
ENABLE: These buttons are used to enable and disable the groups.
You can temporarily disable a Fader group in order to make adjustments to individual fad-
ers by operating the desired channel fader while holding down its [SEL] button.
Fader groups are active only in Fader mode. See “Selecting Fader Modes” on page 44 for
more information.