Owner's Manual

Assigning Scenes to Program Changes 185
DM2000—Owner’s Manual
Assigning Scenes to Program Changes
DM2000 Scenes can be assigned to MIDI Program Changes for remote recall. When a Scene
is recalled on the DM2000, the assigned Program Change number is transmitted. If that
Scene is assigned to more than one Program Change, the lowest Program Change is trans-
mitted. Likewise, when a Program Change message is received, the assigned Scene is
recalled. You must set the MIDI Setup parameters in order to transmit and receive Program
Change messages (see page 184).
Initially, Scenes 1 through 99 are assigned sequentially to Program Changes 1 through
99. Scene #0 is assigned to Program Changes #100.
A Scene to Program Change assign-
ment table, listing initial assignments and with space to note user assignments, is provided
on page 317. This table can be stored to an external MIDI device, such as a MIDI data filer,
by using MIDI Bulk Dump (see page 187), or stored to SmartMedia (see page 231).
1 Use the DISPLAY ACCESS [MIDI] button to locate the Program Change
Assign Table page.
2 Use the cursor buttons to select the PGM CHG. column, and use the Param-
eter wheel or INC/DEC buttons to select the Program Changes.
3 Use the cursor buttons to select the SCENE No/TITLE column, and use the
Parameter wheel or INC/DEC buttons to select Scenes.
You can initialize the Scene to Program Change assignment table by selecting the INITIAL-
IZE button, and then pressing [ENTER].